Stanley BR Series User Manual

44
Cordless Tool
G. Assembly Operation
• With the mandrel collector (Section 2.18.B) and battery installed (Section 2.12), and the tool homed (Section 3.3), place
a blind rivet into the nose piece.
• Move the tool into position, ensuring the nose piece is at a right angle (90°) to the workpiece.
• The tool is equipped with an optional Force Switch. If enabled, the tool must be pressed into the workpiece. Continue
to apply pressure to the nose assembly output of the tool and press the trigger to start the tool’s cycle. Release the
pressure after the cycle is complete.
• NOTE: If the trigger is pulled before the Force Switch is engaged, the tool will not start. The Force Switch and trigger
must both be released prior to attempting to start the tool.
• The tool is designed to run until the rivet’s mandrel is broken, thus completing the tool’s cycle. The mandrel is automati-
cally deposited into the mandrel collector.
• Upon successful completion of the cycle, release the trigger and the tool will return to its home position.
• The mandrel collector should be emptied once it is half full.
CAUTION - DO NOT FORCE THE INSERTION OF A RIVET MANDREL OR BODY INTO THE TOOL. THIS CAN CAUSE DAMAGE TO
THE TOOL.

Stanley BR Series Specifications

General

Brand	Stanley
Model	BR Series
Category	Tools
Language	English