61
Instruction Manual
Index
E. Basic Definitions
• Ballscrew - mechanism that controls the linear travel of the tool
• Blind Rivet - a category of rivet that is completely installed from one side of the joint
• Distance - measured in millimeters (mm)
• Force – measured in kilonewtons (kN)
• Grip Force – the force that the tool must see during Rivet Seek to indicate the presence of a rivet
• Homing – zeroing of the ballscrew linear travel location, required at every tool startup (inactivity or battery replacement)
• Jaws – machined three-piece tool set that grips the appropriately sized mandrel
• Mandrel – the stem of the blind rivet that performs the swaging of the rivet body
• Mandrel collector – cup on the back of the tool that collects the broken mandrel stems, required to be emptied periodically
• Overtravel – when the linear travel of the ballscrew is exceeded
• Rivet Body – portion of the blind rivet that swages against the rear sheet
• Rivet Head – portion of the blind rivet exposed after mandrel break
• Rivet Seek – pulls in the Jaws the specified distance, and within that distance the set Grip Force value must be exceeded
• Snug Force – the force at which point the tool begins to monitor the distance traveled
• Speed – measured in millimeters per second (mm/s)
F. Rivet versus Thread Terms
G. Vacuum Kit
26K100100 - BR12 Vacuum MSC Adaptor Kit
1. 1/4” Vacuum Hose Size
2. 3/16” Vacuum Hose Size (option)
3. 5/16” Vacuum Hose Size (option)
To Previous Page
Loading...
