Stanley Dura-Glide 5300 - Attachment 7 - Fine Tuning Slide Doors

iQ Control Box
01.25.2019
1.800.7.ACCESS • www.stanleyaccess.com • Document # 204144 REV B 37
Copyright 2019, Stanley Access Technologies, LLC. All rights reserved. Reproduction
in whole or in part without the express written permission of Stanley is prohibited.
Attachment 7
Fine Tuning Slide Doors
(Sheet 1 of 2)
Tuning the Stanley Automatic Door
Match your actual door to one from the list of doors described in the aachment. Start by installing these sengs.
Use the guide below to make adjustments to these sengs.
If the door:
OPENS TOO SLOWLY
If it is too slow
If it is too slow
Increase Open Speed. Maximum seng is 99 with keypad or
125 with handheld.
Increase Open Torque
Increase Open Acceleration
NOTES: Max Values go to 125 via handheld.
Open Torque is also used to set the door open force.
HITS THE OPEN STOP
Increase Open Stop to 8 and Open Check Length to 45
Increase Open Brake unl there is good braking.
Increase or decrease unl there is good moon
entering and in Open Check.
When the door braking and moon are under control, reduce the Open Check length as desired.
CLOSES TOO SLOWLY
If it is too slow
If it is too slow
Increase Close Speed to 16
Increase Close Torque
Increase Close Acceleration
NOTE: Close Torque is also used to set the door closing force.
Close Speed and Close Force cannot exceed the value specied by ANSI/BHMA 156.10.