Stanley Erin - Baffle Fitting Instructions

(H) Repeat step (F) for fitting of rear legs. See Fig.5
(G) Lift the rear of the stove and manover the pallet
into the position in Fig.4, where the rear leg
positions are accessible and the stove rests on
the pallet in the centre at the back and on the
two front legs.
Fig.3
Fig.4
Fig.5
(I) Lift rear of stove and remove pallet.
(J) Fit the ashtray with the two 3/4” x 1/4” (20mm x
6mm) screws provided. Tighten all screws. See
Fig.6.
Fig.6
(K) Attach the short timber handle to the ashpit door
using the M8 x 70mm long round head screw
and the spring washer. Attach the long timber
handle to the fire door using the M8 x 90mm
long round head screw and spring washer. See
Fig.7.
Fig.7
5
BAFFLE FITTING INSTRUCTIONS
Step 1.
Remove the inner top by removing the 4 bolts. See
Fig.8.
Inner Top
Bolts
Bolts
Step 2.
Locate the “V” shaped brackets welded to the sides
of the boiler and lay the wide end of the baffle plate
into the brackets. See Fig.9 & Fig.10
Fig.8