20
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
9 Compressor is not large enough for acces-
sory
Check the accessory air requirement. If it is higher than the SCFM or pres-
sure supplied by your air compressor, a larger compressor is needed to
operate accessory.
10 Hole in air hose Replace air hose.
11 Check valve restricted Remove, clean or replace.
12 Air leaks Tighten fittings.
13 Regulator is damaged Replace.
14 Unit operating in damp or humid conditions Move unit to a dry well ventilated area
15 Restricted air intake filter Clean or replace air intake filter
16
Pump oil is low Add air compressor oil (SAE 40) to pump. See Compressor Pump Oil under
Maintenance.
17
Carbon build-up in pump. Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
18
Detergent type oil being used in pump Drain oil and refill pump with air compressor oil (SAE 40).
19
Motor overload protection switch has tripped See Motor Overload under Features.
20
Extension cord is wrong length or gauge Check for proper gauge wire and cord length. See Extension Cords under
Installation.
21
Loose electrical connections
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
22
Possible defective motor or starting
capacitor
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
To Next Page
Loading...
