EasyManua.ls Logo

Stanley FATMAX FMFP70979 - Troubleshooting Codes

Stanley FATMAX FMFP70979
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
English
Compressor is not supplying enough air to operate accessories..............................................8,9,10,11,12,15
Regulator knob has continuous air leak ....................................................................................13
Regulator will not shut off air outlet ...........................................................................................13
Moisture in pump crankcase ......................................................................................................14,18
Motor will not run .......................................................................................................................11,19,20,21,22,23,24,25,26
Troubleshooting Codes
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
1 Pressure switch does not shut off motor when
compressor reaches cut-out pressure
Set the On/Off switch to OFF, if the unit does not shut off contact a Stanley
Tools factory service center or a Stanley Tools authorized service center.
2
Pressure switch cut-out too high
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
3
Tube fittings are not tight enough Tighten fittings where air can be heard escaping. Check fittings with soapy
water solution. Do Not Overtighten.
4 Defective air tank Air tank must be replaced. Do not repair the leak.
WARNING: Risk of bursting. Do not drill into, weld or otherwise modify air
tank or it will weaken. The air tank can rupture or explode.
5 Leaking seals Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
6 Defective safety valve Operate safety valve manually by pulling on ring. If valve still leaks, it must
be replaced.
7
Regulatorisnotadjustedcorrectlyforacces-
sory being used
It is normal for some pressure drop to occur when an accessory is used,
adjusttheregulator as instructedinRegulator under Features if pressure
drop is excessive.
NOTE:Adjusttheregulatedpressureunderflowconditionswhileaccessory
is being used.
8 Prolonged excessive use of air Decrease amount of air usage.

Related product manuals