Stanley FATMAX SFMCMW2651M - Description (Fig. A)

12
ENGLISH
Side Discharge (Fig. A, F)

DANGER: Turn unit off and remove safety key and
batterypacks.
1. To operate mower in side discharge mode, remove the grass
collection bag
10
.
2. Be sure rear door cover
9
isclosed.
3. Lift the side flap
13
and hook side discharge chute
14
onto themower.
4. Release the side flap and ensure the side discharge
chute
14
holds in place before turning moweron.
NOTE: The rear door cover
9
is shaped in such a way that
the opening (at the bottom) cannot be completely closedoff.
Grass Collection Bag (Fig. E)

DANGER: Turn unit off and remove safety key and
batterypacks.
1. Lift the rear door cover
9
and place the grass collection
bag
10
onto the mower so the bag lugs
19
slide into the
slots
20
on the inside plastic surfaces of the handle brackets
as shown in Fig. E. Then lower the rear doorcover.
2. If installed, remove side discharge chute
14
and make sure
side flap
13
is fullydown.
ASSEMBLY AND ADJUSTMENTS

DANGER: To reduce the risk of serious personal
injury, turn unit off and remove the safety key and
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start‑up can causeinjury.
Description (Fig. A)

WARNING: Never modify the area light. Damage or
personal injury couldresult.
1
ON‑OFF switch box
2
ON‑OFF button
3
Safety key
4
Main handle (Upper handle)
5
Lower handle
6
Bail handle
7
Battery cover
8
Cut height adjust lever
9
Rear door cover
10
Grass collection bag
11
Grass collection bag handle
12
Lower carrying handle
13
Side flap
14
Side discharge attachment
15
Handle height adjust levers
16
Upper handle lock levers
17
Upper handle knob
Intended Use
This lawn mower has been designed for consumer lawn
mowingapplications.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
withoutsupervision.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with theappliance.
Attaching Upper Handle (Fig. A, D)
1. Line up the holes on the bottom of the upper handle
4
with the holes on the top of the lower handle
5
. Take care
to not pinch or stress thecord.
NOTE: Make sure the cord is located on the front of both
handles. If it is not it may result in the cord tangling and the
inability to easily store themower.
2. From the outside of the upper handle
4
, slide the handle
lock levers
16
through the two handle holes. Repeat for the
oppositeside.
3. From the inside of the upper handle loosely tighten a
knob
17
onto each handle lock lever
16
.
4. Rotate the upper handle
4
into its operatingposition. Take
care to not pinch or stress thecord.
5. Close the handle lock levers
16
securing the upper handle
intoposition.
NOTE: If the connection between the handle and lever
is too tight or too loose, open the lever and adjust the
depth of the lever by turning the lever clockwise or
counterclockwise.
Close it again until each lever stays
securelyclosed and the handle is secure and will notmove.
Adjusting Handle Height (Fig. A, C)
The mower is shipped in storage mode. You will need to adjust
the handle to operating position beforecontinuing.
1. To unlock the lower handle
5
from the storage position,
open the two handle height adjust levers
15
. The handle
height adjust levers
15
are located on both sides of the
lower handle
5
.
2. Raise the lower handle to the operatingposition. Take care
to not pinch or stress thecord.
3. Close the handle height adjust levers
15
, securing the
lower handle intoposition.
NOTE:
If the connection between the handle and lever is too
tight or too loose, open the lever and adjust the depth of the
lever by turning the lever clockwise or counterclockwise. Close
it again until each lever stays securelyclosed and the handle is
secure and will notmove.