Stanley FatMax TruLaser TLM 300 - Functions; Addition;Subtraction, Area, and Volume; Indirect Measuring (Pythagoras)

D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
HR
H
RUS
CZ
GR
6
Functions
Stanley TLM 300 1.0.0 gb
Functions
Addition/Subtraction
To add or subtract two or more measurements simply
works as follows:
Measurement +/- Measurement +/- Measure-
ment +/- …. = RESULT
Pressing the EQUAL - key {A, 8} ends the sequence
and displays the result in the main line; the actual
measurements are scrolled upwards in the display.
Pushing the CLEAR - key {A, 11} undoes the most
recent operation.
Areas and volumes can be added/subtracted in
exactly the same manner.
Area
Press the AREA - key {A, 3} for the area function. The
corresponding symbol appears in the display. When
both measurements have been taken the result will be
automatically calculated and displayed in the main line.
If you want to measure another area, press AREA -
key {A, 3} once more.
Volume
Press the VOLUME - key {A, 4} for the volume func-
tion. The corresponding symbol appears in the display.
When 3 measurements have been taken the result
will be automatically calculated and displayed in the
main line.
If you want to measure another volume press
VOLUME - key {A, 4} once more.
Indirect Measuring (Pythagoras)
The device can calculate distances using Pythagoras'
theorem. This method is useful when the distance to
be measured is difficult or dangerous to access.
• Make sure you strictly follow the sequence of the
measurements
• All target points need to be vertically or horizon-
tally in the same plane
• Best results can be expected if the device is
turned around a fixed point (e.g. positioning
bracket folded out completely and the device is
held towards a wall)
• It is possible to use the "Minimum/maximum
measuring" by pressing the ON/MEASURING -
key {A, 1} longer. The minimum value is used for
the measurements perpendicular towards the
target respectively the maximum value for the
other measurements.
Indirect Measuring - Determination with two
points
See figure {I}
Press the PYTHAGORAS - key {A, 13} until the
correct symbol appears on the display. The distance
to be measured will flash in the display. Take the
necessary measurements.