2.0 Turning Power On
3.0 Selecting Scanner Depth Mode
Operating Instructions
Prepareing for use
1.0 Battery:
ILLUSTRATION3
BATTERY DOOR
4
Open the battery door on
back of unit (illustration 3)
and connect a 9-volt battery
(not included). Insure to
align the "+" terminal of the
9-volt battery to the "+"
indicator, located inside the
battery compartment. Place battery door onto
case and snap battery door on.
Recommend to replace a new 9 volt battery
when low battery. (flashing green LED).
The ON/MODE Button is located on the right
side (illustration 1) of the hand grip.
1. Depress and hold “ON” button once (1x) to
select to 1/2 ” read depth detection. The
1/2”mode LED will illuminate (illustration 2). The
unit will then calibrate, followed by a beep and a
green LED will illuminate.
2. `Double-click’ / Depress and hold ONbutton
twice (2x) to select to 1” read depth detection.
The 1” mode LED will illuminate (illustration 2).
The unit will then calibrate , followed by a beep
and a green LED will illuminate.
3. “Triple-click”/ Depress “ON” button three
times (3x) to select 1-1/2” read depth
detection. The 1-1/2” mode LED will
illuminate (illustration 2). The unit will then
calibrate, followed by a beep and a green
LED will illuminate.
IMPORTANT: Unit will automatically shut- off if
ON button is released following steps 1,2,3
above.
To Next Page
Loading...
