English
7
English
Installation
1. Ensure�your�product�comes�with�the�items�indicated�on�page�4;�if�not�please�contact
your�dealer.
2. Feed�cables�through�backplate.
3. Use�two�screws�to�attach�backplate�to�wall.
4. Use�two�screws�to�attach�tamper�plate�to�wall.
5. Connect�cable�to�circuit�board—�see�page�5.
6. Configure�reader—�see�page�5.
7. Set�output�format—�see�page�6.
8. Snap�reader�to�backplate�and�secure�with�final�screw.
9. Apply�power�when�all�readers�are�installed.
Notes
•
If�power�is�applied�when�the�reader�is�not�properly�attached�to�the�wall,�a�wall
tamper�condition�is�generated.
•
Do�not�distort�the�back�plate�or�tamper�plate�when�mounting,�e.g.�to�a�back�box,
or�a�spurious�wall�tamper/�case�tamper�condition�may�be�generated.
•
Mount�readers�>3ft�/�1m�apart,�e.g.�on�either�side�of�the�door.�Mounting�on
metal�surfaces�will�reduce�the�reading�range.
•
If�the�reader�is�being�used�to�enter�credential�information�to�arm�a�system,�the
reader�must�be�located�within�3ft�/�1m�of�the�panel’s�main�keypad�or�display.
•
For�outside�readers,�use�corrosion-resistant�fixings�and�apply�silicone�sealant�to
the�backplate�before�fixing�to�the�wall.
•
The�supplied�MOV�(Metal�Oxide�Varistor,�Anglia�Components�P/N
B72207S250K101)�should�be�fitted�across�the�power�terminals�of�the�lock�to
suppress�back�EMF.�Any�suppression�diodes�fitted�in�the�lock/�lock�circuit�must
be�removed.
•
Output�format�and�reader�configuration�can�be�changed�without�disconnecting
the�power�supply.�The�reader�automatically�restarts�with�the�new�configuration.
To Next Page
Loading...
