Stanley PB2500 - Nose Assemblies

7
STANLEY Engineered Fastening policy is one of continuous product development and improvement
and we reserve the right to change the specification of any product without prior notice.
Nose Assemblies
Nose equipment varies according to the blind rivet type being installed. Each nose assembly
represents a unique set of components which can be ordered individually. Component numbers refer
to the illustration below. We recommend maintaining some stock of spares as items will need regular
replacement if worn. Read the Servicing Manual for nose assembly instructions.
Fitting instructions
Mounting the nosepiece
• Select the correct nosepiece for the rivet to be installed. Reference the Accessories Manual for appropriate
nose equipment.
• Tighten the nosepiece (A) into the nose housing (B) by turning it clockwise using 11 mm spanner.
• Select the correct jaw pusher or jaw pusher assembly (R) that matches the Nose Piece selected. Reference
the Accessories Manual for appropriate nose equipment.
• Insert jaw pusher (R) into jaw pusher spring (S)
• Reassemble jaw set (Q) and jaw guide (P) onto Pulling head (T)
NOTE: Do NOT use spanners to mount jaw guide (P) onto front clutch (U). Manual tightening of Jaw guide (P) is
enough to lock onto front clutch (U)
U
T
S
R
Q
P
P
Q
R
S
T
U
C
B
A
B