12 13
OPERATING INSTRUCTIONS
Pre - Operation Preparation
Note: If unit has previously been used, the motor, muffler and
exhaust may still be hot enough to burn. Always exercise
caution when checking the pressure washer.
1. Check that the fuel/engine switch is OFF.
2. Check that the spark plug lead is firmly attached to the top
of the spark plug.
3. Holding on to the cage gently rock the pressure washer
and listen for any noise which may indicate loose items.
If anything appears to be loose either tighten or consult a
service agent.
Filling
Always use clean fresh fuel as specified on page 9. Stale fuel
can cause the pressure washer to run rough and damage the
motor; this will not be covered by warranty.
1. Ensure the engine is OFF.
2. Ensure the fuel tap and engine switch are both OFF.
3. Use fresh fuel as detailed on page 9.
4. Do not fill fuel tank above the top of the fuel filter,
Pic. 8.
5. Ensure that the fuel tank cap is screwed on tightly.
PIC. 8
To Next Page
Loading...
