9
ENGLISH
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
SC121
Charge STANLEY battery packs only with
designated STANLEY chargers. Charging battery
packs other than the designated STANLEY
batteries with a STANLEY charger may make
them burst or lead to other dangerous situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Drill/driver
1 Charger
2 Batteries (S2) or 1 Battery (S1)
1 Instruction manual
NOTE: Battery packs and chargers are not included with
N-models.
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
Description (g. 1)
WARNING: Never modify the power tool or
any part of it. Damage or personal injury could
result.
a. Variable speed trigger switch
b. Forward/reverse button
c. Torque adjustment collar
d. Gear shifter
e. Keyless chuck
f. Battery release button
g. Battery pack
h. Worklight
INTENDED USE
This drill/driver is designed for light fastening and drilling
applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This drill/driver is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• This product is not intended for use by persons
(including children) suffering from diminished physical,
sensory or mental abilities, or for lack of experience
and/or for want of knowledge or skills unless they are
supervised by a person responsible for their safety.
Children should never be left alone to play with this
product.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds
to the voltage on the rating plate. Also make sure that the
voltage of your charger corresponds to that of your mains.
Your STANLEY charger is double insulated in
accordance with EN 60335; therefore no earth
wire is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY
service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
2
; the maximum length is
30 m.
When using a cable reel, always unwind the cable completely.
Assembly and adjustments
WARNING: Prior to assembly and adjustment,
always remove the battery pack. Always switch
off the tool before inserting or removing the
battery pack.
WARNING: Use only STANLEY battery packs
and chargers.
To Next Page
Loading...
