13
EC declaration of conformity
MACHINERY DIRECTIVE
SCH20 / SCH201 - Hammer drill
STANLEY declares that these products described under
"technical data" are in compliance with: 2006/42/EC, EN
60745-1:2009 + A11:2010, EN 60745-2-1:2010
These products also comply with Directive 2004/108/EC (until
19/04/2016) 2014/30/EU (from 20/04/2016) and 2011/65/EU.
For more information, please contact STANLEY at the following
address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of STANLEY.
R.Laverick
Engineering Manager
STANLEY , Europe, Egide Walschaertsstraat14-18,
2800 Mechelen, Belgium
01.2016
To Next Page
Loading...
Need help?
General