ENGLISH • 13
f Always hold the tool and screwdriver bit in a straight
line with the screw.
MAINTENANCE
Your Stanley tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the
tool, remove the battery from the tool. Unplug the charger
before cleaning it.
f Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
f Regularly clean the motor housing using a damp
cloth. Do not use any abrasive or solvent-based
cleaner.
f Regularly open the chuck and tap it to remove any
dust from the interior.
¡Important!To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in thismanual) should be
performed by authorized service centers or other qualified
organizations, always-using identicalreplacement parts.
Unit contains no user serviceable parts inside.
ACCESSORIES
The performance of any power tool is dependent upon the
accessory used. Stanley accessories are engineered to
high quality standards and are designed to enhance the
performance of power tool. By using Stanley accessories
will ensure that you get the very best from your Stanley
tool. Stanley offers a large selection of accessories
available at our local dealer or authorized service center
at extracost.
Note: Accessory must be rated for use at speed equal
to or higher than nameplate RPM of tool with which it is
beingused.
¡Caution! The use of any non-recommended
accesories may be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Stnley product
needs replacement, or if it is of no further use
to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
Batteries
Run the battery down completely, then remove it
from the tool.
NiCd, NiMH and Li-Ion batteries are recyclable. Take them
to any authorised repair agent or a local recycling station.
SERVICE INFORMATION
Stanley offers a full network of company-owned and
authorized service locations. All Stanley Service Centers
are staffed with trained personnel to provide customers
with efficient and reliable power tool service. For more
information about our authorized service centers and
if you need technical advice, repair, or genuine factory
replacement parts, contact the Stanley location nearest you.
To Next Page
Loading...
