How to fix a Stanley STSM1525 that makes unsatisfactory cuts?
If your Stanley Saw is making unsatisfactory cuts, it could be due to gum or pitch on the blade. Remove the blade and clean it with turpentine and coarse steel wool or household oven cleaner. Another reason might be that you are using the incorrect blade for the work you are doing. In this case, change the blade.
Why is my Stanley Saw vibrating excessively?
If your Stanley Saw is vibrating excessively, several factors could be the cause. Start by ensuring that all mounting hardware is tightened securely. Check if the stand or bench is on an uneven floor and, if so, reposition it on a flat, level surface. Inspect the saw blade for any damage and replace it if necessary. Also, verify that the miter scale is adjusted correctly and that the blade is square to the fence; adjust as needed. Ensure the blade is perpendicular to the table, adjusting the guide if necessary. Finally, make sure the workpiece isn't moving by clamping it to the fence or gluing 120 grit sandpaper to the fence with rubber cement.
What to do if Stanley Saw blade does not come up to speed?
If your Stanley Saw blade isn't reaching the correct speed, it might be due to the extension cord being too light or too long. Replace it with a cord of adequate size. Another possible reason is low house current. If you suspect this, contact your electric company.
To Next Page
General