18
If your compressor does not start
• Check that you have plugged the power lead into a
standard 240V 10Amp power point and turned the
switch ON.
• Check that you have turned the air compressor ON/OFF
switch ON.
• The air tank may be full. Use your air tool and the air
compressor should start when the pressure decreases
to 115PSI.
If these tips do not work please have your unit checked by
an authorised service centre.
Call Smart Marketing Group for your closest centre,
Australia. 1300 660 457 N.Z. 0800 474 876.
MAINTENANCE
Daily: Before use
1. Seal the tank drain tap,see page 15, Pic. 12.
2. Check safety valve operation,see page 14, Pic. 10.
3. Check the belt tension, Pic 13. Page 16. Movement
should be 10-15mm. Adjust if required. Page 16.
4. Check for belt straightness. Adjust if required.
Page 16.
After Use
1. Open the tank drain tap,see page 15, Pic. 12
and leave open to allow to drain.
2. Wipe down the compressor.
3. Store safely and securely.
TROUBLE SHOOTING
To Next Page
Loading...
Need help?
General
