6
WARNING
Do not attempt to modify the chainsaw in any way; this will VOID your warranty.
The use of any attachment or accessory other than those recommended in this instruction manual could result in damage to the
chainsaw and could cause injuries to the operator.
This petrol chainsaw complies with Australian / New Zealand and International standards and safety requirements. Repairs should only
be carried out by qualified persons using original spare parts. Failure to do so may result in considerable danger to the operator.
MAINTAIN YOUR CHAINSAW WITH CARE
Follow the instructions for lubricating and changing accessories.
Keep handles clean, dry and free from oil and grease. Ensure that
ventilation slots are kept clean and free from dust at all times.
Blocked ventilation slots can cause overheating and damage to the
motor. Ensure that the air and fuel filters are kept clean at all times.
MAINTAIN THE CHAINSAW IN GOOD
WORKING ORDER
Have all chainsaw service performed by an authorised service agent
with the exception of the items listed in the maintenance section of
this manual. For example: if improper tools are used to remove or
hold the flywheel when servicing the clutch, structural damage to
the flywheel can occur and cause the flywheel to burst.
Make certain the chain stops moving when the throttle trigger is
released. If it does not, do not use until serviced by an authorised
service agent .
1. Never modify your chainsaw in any way.
2. Keep the handles dry, clean and free of oil or fuel mixture.
3. Keep fuel and oil caps, screws and fasteners securely tightened.
4. Use only qualified accessories and replacement parts as
recommended
REMOVE ADJUSTING KEYS & WRENCHES
Form the habit of always checking to see that any adjusting keys or
wrenches have been removed from the chainsaw before operating.
FIRE PRECAUTIONS
Always contact your fire authority before using the chainsaw on fire
restricted days. It is not recommended to use your chainsaw when
a total fire ban is in force. Never refuel your chainsaw while it is
still running. As a precaution it is recommended that an expert is
consulted on obtaining and using a suitable fire extinguisher.
CLEANING YOUR CHAINSAW
Always stop your chainsaw before you commence cleaning.
Always ensure that your chainsaw has cooled, about one
(1) hour, before cleaning and storing. When cleaning your
chainsaw use only a damp soft cloth. NEVER use liquid or
solvents of any type.
CHECK DAMAGED PARTS
Before using the chainsaw it should be carefully checked to
determine that it will operate properly and perform its intended
function.
Check for broken or missing parts and have them replaced or
repaired at an authorised service facility. Check any other condition
that may affect the operation of the chainsaw. A guard or any other
part of the chainsaw that is damaged should be properly repaired
or replaced by an authorised service agent unless otherwise
indicated in this instruction manual.
Any switch that does not operate correctly must be replaced by an
authorised service agent.
DO NOT use the chainsaw if the ‘ON / OFF’ motor switch does
not turn the chainsaw ‘ON’ and ‘OFF’.
DO NOT use the chainsaw if the chain brake does not operate
correctly.
Do not operate a chainsaw that is damaged, improperly
adjusted, or not completely and securely assembled. Always
replace bar, chain, hand guard or chain brake immediately if it
becomes damaged, broken or is otherwise removed.
HOT COMPONENTS
Beware many of the components will get hot during use. Never
touch any of the metal pipes, pump or motor as these may burn.
To Next Page
Loading...
