Help
22
Stairlift is beeping
The batteries are not being charged.
Please note that your stairlift can
continue to run on battery power.
Check that the battery charger is
plugged in. The position of the
battery charger can be found on
page 2 of this guide.
Check that there has not been a
power outage.
Check that the stairlift is at the
top or bottom of the stairs.
If you cannot correct the fault, you
can switch off the beeper by turning
the master power switch to the
off position – see page 7. Then,
please call your Stannah supplier.
Multi-user environments
Switch off the power key before
getting into and out of the chair.
This will ensure that no one else
can call the stairlift when you
are using it.
Make sure the power key is
turned to the on position when
you have completed your
journey. This ensures the stairlift
will work for other users.
Remote calling controls do
not work
Check the batteries – see page 17.
Powered swivel seat does not
work
Please call your stairlift supplier.
You will still be able to use the
manual swivel until a technician
can visit you. Just make sure the
swivel levers are fully raised
when the chair is in the travelling
position – See pages 4 and 14.
To Next Page
Loading...
