Stannah 320 - User Manual

1
Contents
Inhalt
Page
General Installation Instructions 2
Electrical Wiring Diagrams 11
Test and inspection methods 21
Test and inspection methods -
Overspeed Governor 27
Demonstration and handover 28
Tools and equipment 30
Warning Labels 32
Unconfigured Rails 33
Contenido
Table des matières
Sommario
Seite
Montageanleitung 2
Stromlaufpläne 11
Prüf- und Kontrollmethoden 21
Prüf- und Kontrollmethoden -
Übergeschwindigkeitsregler (OSG) 27
Vorführung und Übergabe 28
Werkzeuge und Ausrüstung 30
Warnschilder 32
Details zum Zuschneiden von Schiene und
Zahnstange 33
Página
Instrucciones generales de instalación 2
Diagramas de cableado eléctrico 11
Métodos de prueba e inspección 21
Métodos de prueba e inspección -
regulador de sobrevelocidad 27
Demostración y entrega 28
Herramientas y equipo 30
Etiquetas de advertencia 32
Datos de soportes y corte de rieles 33
Page
Instructions générales pour l’installation 2
Schéma des connexions électriques 11
Méthodes d’essai et d’inspection 21
Méthodes d’essai et d’inspection -
Régulateur de survitesse 27
Démonstration et mise à disposition 28
Outils et matériel 30
Etiquettes d’avertissement 32
Coupe du rail & détails concernant
la crémaillère 33
Pag.
Istruzioni generali per l’installazione 2
Diagrammi elettrici 11
Metodologia di collaudo ed ispezione 21
Metodologia di collaudo ed ispezione -
Limitatore di velocità 27
Dimostrazione e consegna 28
Attrezzi e apparecchiatura 30
Targhette di avvertimento 32
Particolari della cremagliera e della rotaia 33
2
11
21
27
28
30
32
33

Summary

General Installation Instructions

Trailing Cable Connection Diagram

Wiring and Fault Diagnostic Details

Charger Connection Diagram - Upper level

Charger Connection Diagram - Lower level

Zero Volt Connection Diagram

Chair Arm Connection Diagram

Electrical Guide Drawing

Test and Inspection Methods

Introduction to Test and Inspection Methods

Overview of the work method for commissioning and completing the test certificate.

Test and Inspection Description

Details regarding contract number, chair/carriage serial numbers, and motor label presence.

Electrical Tests for Stairlift Inspection

Procedures for testing electrical supply, battery voltage, stall current, trip time, and fuses.

Stairlift Battery Tests and Checks

Steps to measure battery charge voltage, condition, and check for leaks or corrosion.

Mechanical and Operation Tests

Checks for switch operation, control limits, safety gear, and load capacity.

Stairlift User Confirmation

Ensuring the user is fully instructed on stairlift operation and emergency procedures.

Test and Inspection Declaration

Section for distributor details, final test completion, and affixing warning labels.

Test and Inspection - Overspeed Governor

Demonstration and Handover

Tools and Equipment

Warning Labels

Rail Cutting & Racking Details

Stannah 320 Specifications

General

Type	Stairlift
Model	320
Seat Width	460mm
Rail Length	Customized to staircase
Power Supply	Battery powered, continuous charging from mains supply
Safety Features	Seatbelt