CONNECTIONS
Be sure to turn off the amplifier=s power when making connections.
(1) Analog connections
1-1Connect the left (white) and right (red) plugs RCA cord to the amplifier’s left and right “Phono”.
1-2Connect the connector side of the power cord to the set=s power connector terminal (AC IN).
1-3Plug the power cord into an appropriate power outlet.
Check that the power outlet
=
s capacity is sufficient.
(2) Digital connections
2-1Use an RCA cord (not included) to connect the digital output jack.
2-2Connect the RCA cord of step 1 into the digital input jack of a “Digital Processor” or “MD Recorder”.
2-3Connect the connector side of the power cord to the set=s power connector terminal (AC IN).
2-4Plug the power cord into an appropriate power outlet.
Check that the power outlet
=
s capacity is sufficient.
SPECIFICATION
Power supply: AC 115/230v, 50/60Hz:
Power consumption: 15W
Dimensions: 450(W) x 352(D) x 148(H)mm
Weight: 9.5Kg
Motor: 8pole, 3phase, brushless DC motor
Starting Torque: More than 1.6 kgf.cm
Platter: 330mm dia. Aluminun diecast
Pitch: +/-12%, +/-8%
Brake: Electronic brake
Wow & Flutter: Less than 0.20% WRMS (JIS WTD) with 33
1/3rpm
S/N ratio: More than 50dB (DIN-B)
Channel Separation: More than 15 dB
6
To Previous Page
Loading...
