Stanton STR8-30 User Manual

McMullen | Winkler, Waves Records setup, p.1
I. Setting up the Stanton STR8-30 turntable
1. Unpack the turntable (Stanton STR8-30) and assemble
2. Put the slip mat [3] on the turntable (black side facing up, logo facing down – so it
can’t be seen)
3. Connect the RCA audio cable with ground cable to the record player and plug in
the power cord (ATTENTION: the record player can be switched between 120VAC
and 240VAC – it is already set to 240VAC). The setting of the power can be
switched back to 120VAC under the slip mat [3].
4. You might need to adjust the stylus pressure (it was adjusted in the USA but might
have shifted during transportation):
a. Remove the stylus protector, do not touch the stylus tip during the adjustment.
b. Release the arm clamp and lift the tonearm from the arm rest to free it.
c. Rotate the counterweight until the tonearm is approximately balanced

Stanton STR8-30 Specifications

Power

power supply	AC 115/230V~, 50/60Hz
power consumption	9 Watts

Weight and Dimensions

dimensions	450 x 350 x 140 mm
weight	4.6 Kgs

Summary

Setting Up the Stanton STR8-30 Turntable

Unpack and Assemble Turntable

Instructions for unpacking and assembling the Stanton STR8-30 turntable.

Place Slip Mat

Guidance on correctly placing the slip mat on the turntable.

Connect Audio and Power Cables

Steps for connecting the RCA audio and ground cables, and the power cord.

Adjust Stylus Pressure

Procedure for balancing the tonearm and setting the correct stylus pressure.

Connecting the Turntable to the Mixer

Connect Turntable to Mixer

Details on connecting turntable RCA and ground cables to the mixer's PHONO 1 jacks.

Configure Mixer Settings

Setting the input selector, mix selector, cue knob, and sliders on the mixer.

Installation in the Exhibition Space

Turntable and Mixer Placement

Guidelines for placing the turntable and mixer on a pedestal and lighting.

Hang Wall Prints

Instructions for hanging unframed prints using thumbtacks and magnets.

Hang Flatscreen TV and Connect DVD Player

Procedure for mounting the TV, connecting the DVD player, and setting audio levels.