5
3 MACHINE SETTING
106/106C
Weld Control Keypad Locked Cool Control
Power On Indicator Alarm Indicator
SETTING THE WELD AND COOL TIMES/TEMPERATURES.
Set the weld and cool times as below. Place some of the material you wish to seal between the
sealing jaws, close them and cycle the machine by pressing the foot switch/push button. When
the cycle finishes open the jaws, if the material has not welded increase the weld and cool times.
If the weld looks molten decrease the weld and cool times. Repeat the above process until you
achieve a flat strong weld.
Weld Time/Temperature
With the machine turned on press the weld control ▲ or ▼ key and release, the amber weld
indicator will flash. To increase the weld time/temperature press the weld control ▲ key, to
decrease press the weld control ▼ key. As a starting point use 0.7/80. After 5 seconds the screen
will default back and save the figure entered.
Cool Time/Temperature
With the machine turned on press the cool control ▲ or ▼ key and release, the blue cool
indicator will flash. To increase the cool time press the cool control ▲ key, to decrease press the
cool control ▼ key. Cool time should be approximately 3 times weld time. After 5 seconds the
screen will default back and save the figure entered. Certain bag materials may require more or
less cool time than advised above, adjust this as required.
SETTING THE COMPENSATION, KEY LOCK AND JAWS TIMEOUT
During machine operation a residual heat build-up can affect the quality of the weld. To try and
minimise this the sealer has built in compensation which you can set. Firstly, set the weld and
cool times as above from a cold start then repeat the steps as below to achieve consistent weld
quality.
To Next Page
Loading...