9
PUMP INSTALLATION
Follow these simple instructions to install the pump into the heated spout casting.
1. Remove pump from warmer.
2. Swing retainer fastened to the pump heater casting down.
3. Press down on pump plate and turn pump counterclockwise until notches line up with
bumps on black bowl.
4. Lift pump from bowl.
5. Open tin and remove paper label.
6. Place bowl lifter spring in black water bowl with one quart of hot water.
7. Turn on warmer switch "on".
8. Pre-Heat cheese before inserting pump. Pump will not function if cheese is too thick.
9. Be sure bowl lifter spring is placed inside water bowl before inserting container.
10. Place tin or bowl into unit. Bowl lifter spring should be centered under container.
11. Place pump in tin or bowl and line up notches in pump plate with bumps on black bowl.
12. Press down on pump plate until notches are below bumps on black bowl. Turn pump
clockwise until pump spout engages groove in spout casting.
13. Swing lever up to prevent pump spout from disengaging.
GENERAL OPERATING INSTRUCTIONS
7W MODELS
These warmers are designed to use stainless steel serving bowls purchased as an option.
Follow these simple steps for setting up the warmer:
1. Fill the warmer bowl with one and a third quarts of hot water.
2. Turn warmer switch "ON".
3. Place bowl with food product into the water bowl. If using No. 10 tin, open tin and pour
contents into stainless steel bowl.
4. Turn the control knob to "Serving Temperature" position. Because the consistency of
different foods varies, and because liquids and solids absorb heat at different rates, it
is impractical to specify an exact dial setting. However, the letter "V" is in the center
of the serving range. At this point the temperature is approximately 145
o
F, the proper
holding temperature for fudge. When the dial is set at the letter "N" the temperature is
approximately 170
o
F, a good holding temperature for cheese sauce. After preheating,
set the thermostat to the desired temperature.
5. Turn the control knob to the extreme left position "OFF" when not in use. Turn warmer
switch "OFF" to turn power off to unit.
6. Do not keep unit on high heat for more than 45 minutes, as the food product may
become overheated.
To Next Page
Loading...
Need help?
General
