5
HELPFUL HINTS
1. During long slack periods of the day, turn off the baker. During short slack periods, leave
unit on with the grids closed. This will help minimize carbon buildup.
2. Do not store batter in the refrigerator and expect the same speed in baking. Cold batter will
take longer to bake.
3. For proper release of wafes it is important that the batter contain the proper amount of
shortening.
CLEANING
For non-coated grids: Clean outside of baker every day that it is in use. Clean grids with hot
water and mild detergent and a nylon brush to prevent a buildup of carbon from forming. In
order to remove carbon from grids, unplug the unit, place ammonia soaked cloth over bottom
grid, close and leave overnight. A nylon brush may then be used to remove the carbon
buildup. If you use a commercial carbon remover, make sure that it is safe for aluminum.
CAUTION
DO NOT CLEAN USING A WATER JET OR SIMILAR DEVICE FOR CLEANING.
DO NOT IMMERSE IN WATER AT ANY TIME.
CAUTION
DO NOT CLEAN TEFLON
®
GRIDS WITH ABRASIVES. THIS WILL VOID THE
WARRANTY.
For cleaning the baker outside use only a soft cloth and mild soap to keep the exterior surfaces bright
and shining. Do not use detergents, strong abrasives or metal scouring pads on the exterior surfaces
of the wafe baker.
To Next Page
Loading...
Need help?
General
