Starcraft 2005 - Installation of Spare Tire, Clothes Hanger, and Bunk Lights; Spare Tire Installation; Clothes Hanger Installation; Bunk Light Installation

3.
All
existing
male
snaps
should
be
fastened
to
the
bunk
board.
Use
the
female
snap
located
on
the
hideaway
skirt
to
space
the
male
snap.
4.
Insert
four
metal
stake
hooks
through
the
metal
grommets
on
the
bottom
of
the
skirt,
Press
firmly
into
the
ground.
(See
Drawing
2.)
al
ss |
es
|
BOTTOM VIEW OF SLIDE-OUT BACK BUNK.
Drawing 2
Spare Tire Installation
All
Starcrafts
have
a
rear
spare
tire
mount
assembly.
For
Installation, proceed as follows (see Drawing 3}:
1. Insert bolt (A) through the square hole in the spare
tire bracket (D).
2.
Holding
bolt
(A)
in
place,
slide
one
retainer
washer
(G) over thread portion of port.
3. Follow steps 1 & 2 for both bolts.
4, Place the spare tire over the two bolts and attach
ruts (C) and tighten securely.
A BOLT IA)
a
By
a
Spare Tre Braciat
x
Clothes Hanger Installation
The clothes hanger may be installed as shown below at the
appropriate location, depending on what model camper you
have.
fur (
Drawing 3. Starcraft spare tire bracket,
bolt, washers & nut assembly.
elder
Comes HANGER
2107
2407
SS
R
| FRONT.
ve
|
1707
if
2406
Dan
1701
2106 >No Clothes Bar
2410
Bunk Light Installation
Dome
lights
now
contain
a
12
volt
power
jack
for
connecting
remote bunk lights. See Fig. 22 & 23.
|. Place the 12 volt light at midpoint on the tent roof and
shap it to the tent support bar. The cord should be
‘extended toward the light receptacle.
. It is recommended that you wrap the cord around tent
support bar a minimum of two times.
Insert
the
cord
plug
inta
the
12
volt
jack
in
the
dome
light.
CAUTION: 12 volt lighting will produce heat. Care
should be taken when handling the fixture after the
light has been on for some time,