Starcraft 2005 - Page 38

Centennial Entrance Door
Set-up
After unhooking and leveling camper, crank the roof up
and set the stabilizer jacks. Install all the bed braces and pull
both beds out. Set up the bunkends and zipper the tent panels
closed at each lifter.
Unlatch the two wing catches on the off door side of the
trailer that are holding the entrance door to the ceiling. Let the
door hang on the cables. On the door side of the trailer, you
will need to lift the entrance door slightly to unhook it from the
storage bracket. Move the door toward the off door side of the
trailer slightly to allow downward movement of the door.
Lower the door assembly while pushing the entire door
outside of the camper. The top of the door will remain inside the
camper. Lift the door vertically while fitting the top of the door
under the roof sideboard. Turn the two wing catches located
Cn the roof sideboard to hold the top of the door securely.
Open the door and pull inward on the sides of the door frame
until itis seated in the door jambs. Turn the four wing catches
on the door frame to secure it to the jambs. Fasten the tent
Panel Volcro to the entrance door Velcro.
To store door for travel, reverse this procedure.
36
Centennial Sink Faucet
Storage °
Before closing the camping trailer dow, itis important that
the sink faucet be lowered to allow the beds to be pushed in.
Otherwise, serious damage to the faucet spout will occur.
Turn the sink faucet spout toward the sink. Grabbing the
“U" shaped handle in the moveable countertop with one hand,
lift slightly white turning the thumb lock with the other hand.
Release the hold on the “U” shaped handle and the countertop
with faucet will gently lower into the cavity behind the sink.
The faucet spout should be turned into the sink before
trying to push the beds in. If not, lift the moveable countertop
by the “U” shaped handle high enough to turn the spout the
correct direction.