111
pump will run and pressurize the water lines, and water should ow from the xture.
5. Siphon Valve should be OFF.
Used to ll the water tank if no pressurized water source
is available. Water can be poured directly into the fresh water tank using the gravity ll inlet
on the outside of the RV.
Fills the water tank from a pressurized
water source attached to the utility center panel.
1. Set the blue city water / tank ll valve at the utility center to
the position (horizontal) pointing to the left.
2. At the water pump: the water tank shuto valve should be in
the OFF position. Siphon valve should be in the OFF position
(Fig 2).
3. Attach a pressurized water source to the fresh water connec-
tion inlet. You should use a non-toxic drinking water hose
dedicated only to supplying fresh water to the vehicle.
4. When the water source is turned ON, water tank will ll.
– LEDs will indicate the level in the water tank.
5. When water tank is full, turn o the pressurized water and disconnect the hose from the
water source rst, then disconnect at the utility center panel.
allow sanitizer into the water lines (but not the water tank). The city
water /tank ll valve at the utility center is not used for this operation. It can remain in the
CITY position. Refer to Sanitizing the Plumbing System.
This setting will allow antifreeze into the water lines (but not the water tank). The city water
/ tank ll valve at the utility center is not used for this operation. It can remain in the CITY
position. Refer to Winterizing the Plumbing System.
When your RV is new.
At the beginning and end of each season.
When the water system becomes contaminated or every three months of use.
Prepare a chlorine solution using 1/4 cup of household bleach (sodium hypochlorite solu-
tion) to one gallon (3.785 liters) of water in a container. Prepare one gallon of solution for
every 15 gallons of tank capacity.
This will result in a residual chlorine concentration of 50 ppm in the water system and
should remain in system for at least 4 hours. If a 100 ppm concentration is prepared, use ½
cup of household bleach with one gallon of water. One gallon of the solution should be used
for each 15 gallons of tank capacity. Allow to remain in system for at least 1 hour.
Fresh water tank sizes vary by model. Contact your dealer
or Customer Service for your specic tank size.
To Next Page
Loading...
