SF-2300S Gantry CNC cutting machine controller manual
BeiJing Starfire Control Technology Co.,Ltd QQ：1908817881 www. starfirecnc.com
Please read this manual carefully before using the system
Use notice:
1. On the packing, please check the system have damaged during the transit,
whether the content listed on the packing list and the items in the cabinet.
2. This manual applies to Beijing STARFIRE control technology co., LTD., peak
production of SF-2300-s-QG NC cutting machine system.
3. Please check whether the power grid voltage is correct. Between the grid and the
system to use AC220V isolation transformer, to ensure the safety of the system
reliable work and personnel.
4. Numerical control system requires working environment temperature 0 ~ + ℃
40 , relative humidity of 0 ~ 85%.℃ Such as it works high temperature, high
humidity and corrosive gases under the environment, need to take special
protection.
5. CNC system wiring to correct parts, good ground contact.
6. CNC system does not allow charged plug all cable at the back of the case, the
resulting consequences. Or company refused to guarantee.
7. CNC system output port at the back of the line, does not allow with other power
cord short circuit, otherwise will be burned CNC.
8. Under the environment of high dust, dust the machine needs to be done
protection, and require regular cleaning dust, as far as possible to ensure that the
numerical control system clean.
9. NC system should be managed by personnel, should carry on the training to
operators.
10. CNC system is not allowed to use inner the AC/DC power supply to connection
to other electrical appliances.
11. In case of problem, please contact with the company. Don't in unfamiliar
situations to tear open outfit, the transformation system.
12. The maintenance system and machine tools, daily maintenance and check once
per class. Every month performs maintenance level 2.
Every six months perform maintenance level 1.
13. CNC system Settings of various parameters, we will strictly in accordance with
this manual or order of added set. Such as setting parameters within the prescribed
scope, or can make the operation of the CNC system and even damaged.
14. The LCD panel of the system is fragile goods, pay attention to during the process
of using LCD for protection.
15. This system technical indicators in the event of a change, without prior notice.
16. Note:
System's USB port output power is very small, only for the use of USB flash drive,
can't pick up any other USB devices, in case of damage.
17. In the internal and external keyboard switch power must be followed.
18. Special announcement:
Warranty, the warranty of this product range is from the date of delivery, 12 months,
according to the instructions allow what happened under the condition of fault.
Warranty and warranty beyond the treatment of the failure is a subscription service.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn
To Next Page
Need help?
General
