Starfire SF-HC25C3 - Recommended NC Settings for Plasma

SF-HC25C3 Height Controller
23
6.3 CNC system recommended settings (STARFIRE CNC) plasma mode
The initial position detection chooses: 0.
The initial position detection logic: 0.
Cutting positioning delay: 0.
Cutting up delay (M70): 1 second.
Cutting down delay (M71): 0 second.
Arc pressure detection: 1.
Perforated delay: 0.
The corner to close the height distance: 10 mm.
To break the arc end in advance distance: 2 mm.
Raise the automatic signal delay: 3 seconds.
7.Troubleshooting
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn