Table 3-2-45PIN Connector-connect panels
No. Character Illustration
Remark
5V+ Power Panel 5V power supply
Never to use others
RXD Input Serial data input
TXD Output Serial data output
GND Power Panel power supply
GND Power Used for shielding
Figure 3-2-4
Here attachment random has been included in the accessories, length of 100
cm.
3.2.2 Points linking piece function introduced
Points linking piece is after the plasma cutting torch arcing voltage according
to certain proportion is reduced, and according to the isolation of converted to
reflect the cutting nozzle and the function modules of the low voltage signal of
cutting plate height, is the height measurement and control of plasma cutting
indispensable accessories. Points linking piece can choose according to need
to install location, it is recommended that the installation within the plasma
power supply and the platen each interface description as shown in figure
3-2-5.
To Next Page
Loading...
