ALWAYS read, understand, and follow procedures in operator’s Manual before attempting to operate
equipment.
Stop the engine when leaving the cutter unattended.
ALWAYS be sure to operator is familiar with proper safety precautions and operating techniques before
using the cutter.
Block the unit when leaving or when using on a slope.
Maintain this equipment in a safe operating condition at all times.
ALWAYS stop the engine before serving, adding fuel and oil.
2
NEVER Run engine without air lter. Severe engine damage may occur.
ALWAYS service air cleaner frequently to prevent carburetor malfunction.
ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean,
dry location out of the reach of children.
NEVER operate this cutter in areas that contain combustible material or fumes. Fire and/or explosions
may result from errant sparks from the equipment.
DO NOT operate this equipment unless all guards and safety devices are attached and in place.
Caution must be exercised while servicing this equipment. Rotating and moving pans can cause injury
if contacted.
Keep all inexperienced and unauthorized people away from the equipment at all times.
Unauthorized equipment modications wilI void all warranties.
DIAMOND BLADE SAFETY
Use appropriate steel centered diamond blades manufactured for use on concrete cutters.
Examine blade anges for damage, excessive wear and cleanliness before mounting blade.
Blade should t snugly on the shaft and against the inside/outside blade anges
ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks, dings, or aws
in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.
Ensure that the blade is marked with an opera ting speed greater than the blade shaft speed of the cutter.
Only cut the material that is specied by the diamond blade. Read the specications of the diamond blade
to ensure the proper tool has been matched to the material being cut.
ALWAYS keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees,
Ensure that the diamond blade does not come into contact with ground or surface during transportation.
DO NOT drop the diamond blade on ground or surface.
The engine governor is designed to permit maximum engine speed in a no-load condition. Speeds that
exceed this limit may cause the diamond blade to exceed the maximum safe allowable speed.
Ensure that the blade is mounted for proper operating direction.
IMPORTANT SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
