Starkey StarLink Remote Control 2.0 Quick Tips

Lock/Unlock
LED Indicator
Light
Volume Up
Program Change
Volume Down
Favorite
Pairing
The Remote Control 2.0 must be paired to interact with compatible 2.4 GHz hearing aids on the Neuro Processor
and Thrive platforms. Pairing occurs once, then the hearing aids and Remote will automatically recognize each other.
The Remote can be paired within the fitting software or outside of the fitting software. Compatible 2.4 GHz hearing
aids on the Neuro Processor or Thrive platform can be paired with one Remote.
Pairing within Pro Fit
1
Launch Pro Fit and connect hearing aids.
2
Select Accessories from the Preparation Session
in Pro Fit or from the Flyout Menu .
3
Ensure the Lock switch is in the Unlock (up) position.
4
Place the hearing aids within six inches of the Remote.
5
Place the Remote in pairing mode by pressing the
Favorite button for 5 seconds. The LED will rapidly blink.
6
Select to put the hearing aids into pairing mode.
7
Pairing is successful when the Remote image displays
on the accessory screen.
8
Use the dropdown menu below the Remote image
to set the Favorite button configuration.
9
Select pairing information for pairing instructions if needed.
Neuro + Thrive Platforms
QUICKTIP
StarLink Remote Control 2.0
6
7
8
9

Starkey StarLink Remote Control 2.0 Specifications

General

Device Type	Remote Control
Wireless Technology	Bluetooth
Compatibility	Starkey hearing aids
Battery Type	CR2032
Range	Up to 10 meters
Controls	Volume, mute