Starline GLV - Troubleshooting; Filling and Heating Issues; Cycle Start and Performance Issues; Foaming and Rinse Issues

8 GLV - Operator Manual 160819
Fault Cause Remedy
Filling
Not filling Water supply valve shut Check Water supply
valve
Door Switch not operating Check Door is closed
Filling during wash cycle Upstand not fitted properly Check Drain upstand is
fitted
Heating
Dishes not hot enough Machine not rinsing Check water supply
temperature
Rinsing but not hot Check water supply
temperature & arms
spinning freely
Cycle start
Does not start Door switch Check door is closed
Cycle Finish
Wash too long Water supply cold Check water supply
temperature
Performance
Poor wash result Detergent not used Use quality low foam
product
Overloading racks Do not overload racks
Not pre-rinsing Use Fisher pre-rinse
Wash arms not rotating Remove and clean
arms/check bushes
Wash jets blocked Remove arms and
clean jets
Excessive soiling Pre-rinse/use long
cycle
Unrealistic expectation E.g. baked on soiling
requires pre-soaking
Poor rinse results Rinse jets blocked Remove arms and
clean jets
Rinse arms not turning Remove arms, clean
jets, check bushes
Poor racking procedures Do not overload racks
Excessive wash tank soil build up Pre-rinse, change
wash water regularly
Not drying Poor wash/rinse performance Refer above
Low temperatures Check heating systems
Drying agent not used Use quality drying
agent/rinse fluid
Foaming Wash Excessive Rinse Fluid Adjust Rinse Fluid
Injector
Troubleshooting