StarLine S9 v2
16
and then followed with serial ashes at which button must be
released.
Command Button push
Arm / disarm 1 short
Enable / disable Anti-hijack by a tag away long 1 level
Enable / disable Service mode long 2 level
Replacing a tag battery
Wireless tag (transponder) is equipped with CR2032 type Li-ion battery.
Tag battery discharging is indicated with 3 sounds of
embedded main unit buzzer (or siren) at ignition On and
owner is notied with text message to his phone number.
Then battery must be replaced as soon as possible.
To replace battery open a tag casing carefully with a at metal or plastic
item, remove discharged battery from slot. Install a new battery in the
slot observing correct polarity (positive side up, as shown on picture).
Then x a cover back. Tag is ready for operation.
A smartphone with support of Bluetooth 4.2 and above can also be used
as a tag. See Devices registration article to pair a smartphone as a tag.
To Next Page
Loading...
