Need help?Do you have a question about the Starrett 3814 and is the answer not in the manual?
General| Brand | Starrett |
|---|---|
| Model | 3814 |
| Category | Test Equipment |
| Language | English |
Details on correctly placing weights on the weight bar for operation.
Instructions for installing the diamond or ball penetrator correctly.
Steps for setting the weight selector and aligning the dial for initial testing.
Steps to refill the hydraulic oil in the handle buffer for smooth operation.
Instructions for positioning and drilling mounting holes for the tester.
Procedures to ensure the tester is perfectly level for accurate measurements.
Guidelines for preparing test specimens and selecting the correct anvil.
Detailed steps for performing a hardness test using the tester.
Essential checks before performing fine adjustments on the tester.
Step-by-step guide for fine-tuning the dial indicator for accurate readings.
Identifies causes and solutions for inaccurate hardness measurements.
Addresses variations in readings when using test blocks.
Solutions for the dial indicator needle moving too fast at test start.
Lists scale symbols, indentor types, and their corresponding forces.
Details typical materials and conditions for each hardness scale.
Factors to add to test results for convex cylindrical surfaces on C, A, D scales.
Factors to add to test results for convex cylindrical surfaces on B, F, G scales.
To Next Page
