S8010
126
ENGLISH
4. KEEP the speed and pressure so that it is possible to cut without
overheating the drill bit. APPLYING too much pressure may cause:
- Machine to overheat;
- Bearing wear;
- Sprung or burnt drill bits;
- Irregular or decentralized holes.
The Drill/Driver S8010 has as accessory a Bit (fi gure 13) clamped by a Clip
(Bit Storage).
The Bit is used to tighten or loosen screw head as Phillips or Slotted.
The installation is similar of a drill and can be tightened by Keyless Chuck.
It is RECOMMENDED REMOVE and STORE on the Bit Storage whenever the
machine is off.
BIT STORAGE
(CLIP)
BIT
SCREWDRIVER OPERATION:
FIG 13
To Next Page
Loading...