StarTech.com ARMDUALV - Page 15

Instruction manual
11
4. Thread the cable-management clip and the cap onto the lower pole.
5. Screw the lower pole into the top of the grommet collar. (gure 7)
gure 7
Lower pole
Cable-management clip
Cap
Grommet collar
6. Use the 3 mm hex key to tighten the screws in the grommet collar, and push the
cap down so that it sits ush against the top of the grommet collar and covers the
screws. (gure 8)
gure 8
Cap
3 mm hex key
Grommet collar