StarTech.com ARMDUALV - Page 14

Instruction manual
10
Use the grommet mount to attach the ARMDUALV
1. Thread a Phillips screwdriver through the hole in the top of the desk clamp and
unscrew the screw from the plate and rod.
2. Remove the rod from the bottom of the desk clamp. (gure 5)
Tip! Keep the screw, plate, and rod in a safe place so that you can use them again if
you want to switch back to the desk clamp mount.
gure 5
Screw
Desk clamp
Plate
Rod
3. Remove the backing from the ve rubber pads and ax them to the underside of
the grommet collar. (gure 6)
gure 6
Rubber pad
Grommet collar