IInnssttaallllaattiioonn
These instructions assume that the display has at least one available set of inputs that
use Component Video, as well as RCA or Digital Coax audio capability, and that all the
devices have their cables attached. You may need to disconnect an existing device from
the display to make an input available and re-connect that device once the video switch
has been suitably configured.
Connecting Devices to the Switch
NOTE: These instructions assume that all devices connected to the switch use the same
connection that the switch will use to connect to the display (i.e. the switch connects to
the Component Video input on a television, so all devices will be connected to the switch
using Component Video cables).
1. Situate the switch near the display and the devices you wish to use with the switch.
2. Using the color-coding on the jacks, connect one of the designated components to the
corresponding ports marked IN1.
3. Connect up to three additional devices following the instructions in step 2.
4. Connect RCA audio or digital coax cables and a component video cable to the ports
labeled OUTPUT on the video switch. Connect the opposite end of those cables to
the appropriate connectors on the display (normally marked as A/V IN or similar).
5. Connect the power adapter (provided) to the port marked DC 9V on the video switch.
Connect the opposite end to a wall outlet or other suitable power source.
The video switch is now ready to use.
Instruction Manual
2
DC 9V Output
Input 4 Input 3 Input 2 Input 1
To Next Page
Loading...
