3
Hardware Installation
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
NOTE: To use encryption, the SATA drive must be initialized and formatted after setup.
This will erase all data on the drive.
1. Open the enclosure by locating the thumb ridges. Pressing down slightly, slide the
back pane away from the top edge.
2. Connect the the 2.5” SATA Hard Drive
To Next Page
Loading...