7
• To adjust the Scan Rate which sets the duration before switching to
the next computer in Auto Scan:
Left Ctrl + Left Ctrl + F3
The SV431H sends one to four beeps indicating scan intervals of 3,
8, 15 and 30 seconds respectively.
• To adjust keyboard typematic rate (characters/sec), this setting
over-rides that of the BIOS and any operating system:
Left Ctrl + Left Ctrl + F4
The Sv431H generates 1 to 4 beeps corresponding to 10, 15, 20 and
30 characters/sec respectively.
Cascade Configuration
Connection
Before connecting a device (a computer or any other SV431H) to the
master under power, you must turn off the devices. Only the PS/2
ports are operable for cascade operation.
Computer Selection by Hot Key Command
The first digit is the port address of the Master unit (1~4) and the
second digit is the port address of the Slave (1~4). Please note that
only the Master’s PS/2 ports can be connected to a Slave’s Console
port.
Left Ctrl + Left ctrl + 1 + 3
Selects a computer connected to PS/2 port 3 of a Slave connected to
PS/2 port 1 of the Master.
To Next Page
Loading...
