SteakAger PRO 40 - Table of Contents

Contents
Introducon
Important Safeguards
Installing the PRO 40
Features and Funcons
Operang Instrucons
Cleaning and Maintenance
Warranty Terms and Condions
For Your Records:
1
2
3
4
5
6
7
8
Please write down the serial number below for
future reference. The number is located on the
rangs label at the back of your unit. You may also
want to staple your receipt to this manual as it
is proof of your purchase, and is also needed for
service under you warranty.
• Moving your PRO 40
• Placing your PRO 40
• Leveling your PRO 40
• First Time Operang Instrucons
Serial Number :
1
18
app setup
App Usage and Troubleshoong
• To set an aging mer press “Add New Cut of Beef”. You can then use the
scroll style interface to select the cut of meat along with the amount of
desired me.
• If you scroll to the boom of the list of beef cuts you can press the “+”
buon and enter a custom cut or any addional beef cuts that arent
preset into the App.
• To delete or edit the aging mer at anyme, swipe le on the set me and
you will see a “Edit” and “Delete” buon on the right side of the mer.
• To locate the seng inside the App locate the “Gear” icon in the top right
of the home page. This will take you to a page with a list of opons.
• SteakAger Devices List : To add or delete any SteakAger device you will
need to press “SteakAger Devices List”. Inside this menu you will see all of
the devices that are connected your account. Swiping le on a device will
allow you to either delete or edit the device. Pressing the “+” buon in the
top right of the screen will allow you to add any devices that are near you
(within Bluetooth range). If you are trying to connect to a unit near you
and you receive an error message “No SteakAger Devices Found”, unplug
and plug the SteakAger back i and try connecng again.
• Change SteakAger Type & Name : This will allow you to change the name
an unit designaon fo the SteakAger that you are currently viewing.
• WiFi Conguraon : In this menu is where you can change, view, and
connect to networks for monitoring over WiFi. If you do not see your
network in the list, try to refresh the menu with the refresh buon in the
top right.
• Edit Meat Types : If you are interested in remvoing, eding, or adding any
extra meat types that are not found in the presets menu this is where
you are able to do that. These changes will be for your meat aging mer
sengs.
• Measuring System : Changing between C/F and lb/kg can be done in this
menu.
• Change Connecon Type : To switch between Bluetooth and WiFi
monitoring go into this menu and select the monitoring type. If swapping
from Bluetooth to WiFi, you may be prompted to resign in or to create an
account if you havn’t already. **Refer to “Connecng to your SteakAger -
WiFi Connecon”
• Reset Applicaon : This is mostly used to do a full reset on the App if it is
not working properly. If you are experiencing issues with connecon or a
lot of error messages using this command should solve this. You can also
use this if you are wwanng to wipe your app clean for a new account
without having to uninstall and reinstall.
OPERATING
INSTRUCTIONS
Aging Timer
App Setup and Usage