WWW.STEALTHCAM.COM
Toll Free 877-269-8490
Inserting SD memory card
Insert SD memory card in to the SD card slot completely and in the
correct direction as shown by the sticker located at the side of the
housing.
To remove the SD memory card, depress the SD card and pull out the
card gently.
SD cards must be clean (no images from other sources). If you are using
the SD card from other cameras, please make sure to format the SD card
in your computer prior to use in your camera. New cards are good to use
straight from the package.
FORMAT – Definition: When you format a SD memory card, the operating
system erases all information and files on the card. Then it creates an internal
address tables that it later uses to locate information and files. Formatting
also removes all Hidden System files as well. Basically it cleans your SD
memory card just like if it was brand new. Please make sure to follow the
guidelines listed below:
SD Card size: 2Gb or below, format using File System type “FAT”.
NOTE: Make sure camera is in the OFF position whenever adding or
removing memory.
WARNING:The above camera will not accept
Class 10 or above speed rating SD memory cards.
To Next Page
Loading...
Need help?
General
