STC-WD1
www.stealthcam.net Toll Free 877-269-8490
10
• Make sure the camera power switch is OFF and power source
switch on BATTERY.
• Insert the battery pack plug into the DC 12V jack of the bottom
of camera housing
• Turn the camera power on.
Please make sure the voltage and polarity (+/-) are correct
before connection. Incorrect voltage or polarity (+/-) will
damage the camera.
Memory Options
Your STC-WD1 camera is equipped with 16MB built in flash
memory. The camera is also equipped with an expendable
media card slot capable accepting up to 1GB SD card (sold
separately). With no memory card inserted into the slot, the
camera will use the built in 16MB memory. If a SD card is
inserted into the slot then the camera will bypass the built in
memory and utilize the SD memory. The front counter display will
To Next Page
Loading...
Need help?
General
