STC-WD1
www.stealthcam.net Toll Free 877-269-8490
11
show the number of images on the built in memory unless the
expansion card is inserted at which point the counter will only
show the number of images in the expansion card.
Inserting SD card
Make sure camera is in the OFF position whenever adding or
removing memory.
• Insert SD memory card in to the SD card slot completely and in
the correct direction as shown by the sticker located at the side
of the housing.
• To remove the SD memory card, depress the SD card and pull
out the card gently.
SD cards must be clean (no images from other sources), if
you are using the SD card from other cameras, please
make sure to format the SD card prior use in the STC-WD1
(See format section on page 18). New cards are good to
use straight from the package.
To Next Page
Loading...
Need help?
General
