Stealth DIGI-TIG200PD - Page 5

STEALTH DIGI-TIG200PD
1.Memory chanel LED 2. Data Display meter 3. Parameter Select function 4.indicating light of power
5. S -- unit of up & downslope time & pre& post flow time
% -- unit of AC balance &peak time on
Hz-- unit of pulse freq.&AC freq.
（（
6. indicating light of Parameter Select function Pre-flow /Start current/Up slope/Welding Amps Pulse peak
）
amps /peak time on/ pulse freq./base Amps/down slope/end current/post flow/AC freq./ AC balance/)
7.AC
slector
AC WAVE FORM: advanced square/soft square/triangular square / sine square
8.warning indicating light
9. MMA slector
DC-/DC+
10.TIG PULSE slector
11.TIG slector
DC TIG/AC TIG
12. 2 T/ 4 T slector
（ ） （）
13. Data Display Adjustment Knob 15. output"+" Welding holder 16. output"-" Ground clamp
17.argon out 18.argon arc control (or remote control)
19.Amp Adjustment slector (remote control)
panel/ pedal /finger torch
20. power switch
21.argon inlet 22.power supply 23.safety earthing column 24.fan
25.HF/Lift TIG slector
1
2
3
4
3
7
10
11
12
8
5
25
13
9
6
6
19
1. Memory channel LED
2. Data Display meter
3. Parameter Select function
4. Power light indicator
5. S = Unit of up and downslope time and
pre and post flow time
% = unit of AC balance and peak time on
Hz = unit of pulse frequency and AC
frequency
6. Parameter Select function: Pre-Flow, Start
Current, Up Slope, Welding Amps, Pulse
Peak Amps, Peak Time on, Pulse
Frequency, Base Amps, Down Slope,
End Current, Post Flow, AC frequency,
AC balance
7. AC selector
8. Warning indicating light
9. MMA selector: DC– / DC+
10. TIG PULSE selector
11. TIG selector: DC TIG / AC TIG
12. 2T / 4T selector
13. Data Display adjustment knob
15. Output Positve (welding holder)
16. Output Negative (ground clamp)
17. Argon out
18. Argon arc control (or remote control)
19. Amp Adjustment Selector (remote control):
Panel, Pedal, Torch
20. Power switch
21. Argon inlet
22. Power supply
23. Safety earthing column
24. Cooling fan
25. HF/Lift TIG selector