!
!
!
Controller Maintenance
Safety and operation information of the controller
Warning:
If the installation and operation instruction is not read or understood, do
not install. In case there should be any dangerous installation and improper
operation.
Install the controller based on the installation instruction otherwise, the temperature in
the steam room will be too high or not heated enough.
If the controller is installed outside the steam room, the temperature sensor must be
installed in the steam room.
Caution:
Do not install the controller wire in the same conduit with high voltage electric
wire. Do not install close to hot water or steam pipe.
Important:
Before installing the controller, make sure the steam generator power is
off otherwise the controller may be damaged.
The instruction includes important safety, operation and maintenance information.
Keep the instruction in the user's hands.
If the steam generator is damaged or does not work normally, do not continue to install
or use the controller. Turn main power supply off.
User Manual
1. Use soft cloth with a mild soap/water to clean controller
2. Do NOT use harsh chemicals or cleaning products.
3. Do NOT mount controller directly over the steam nozzles.
4. If controller is readout is not stable or damaged, turn main power off and call a
service electrician to replace it.
15
To Next Page
Loading...