Steamfast SF-210 - Using Your Everyday Steam Cleaner; Filling Boiler; Refilling Boiler

ENGLISH
|
9
Using Your
Everyday Steam Cleaner
FILLING BOILER
1. Place Everyday Steam Cleaner on a at, level surface.
2. Make sure power cord is unplugged from electrical outlet.
3. Cautiously remove Boiler Cap by unscrewing it in a counter-clockwise direction, and lift it off.
CAUTION: Refer to relling procedure below for additional safety precautions that must
be taken when relling the unit after it has been in use.
4. Boiler should always be emptied after each use. If it was not emptied after the previous use,
empty it now – this will make it easier to ll with the correct amount of water.
5. Fill included Measuring Cup with 6 oz (180 ml) of water.
NOTE: In order to extend the life of your Everyday Steam Cleaner and keep it functioning
at it’s maximum potential, it is highly recommended that distilled or de-mineralized
water be used in Boiler.
6. Carefully pour water from Measuring Cup into Boiler through ll hole.
NOTE: Do not exceed the Boiler’s maximum capacity of 6 oz (180 ml). This will ensure
a better ow of steam with minimal dripping water.
7. Replace Boiler Cap, screwing it in a clockwise direction to tighten. Make sure it is screwed on
securely to prevent hot water or steam from escaping.
REFILLING BOILER
If unit has been in use, always use the following safety precautions before removing
the Boiler Cap to add water:
•
Allow unit to cool for 5-10 minutes.
•
Press and hold Steam Trigger to release all remaining steam. Steam can remain pressurized
inside Boiler for up to an hour after use.
WARNING: Failure to follow these precautions may result in burns from escaping steam
when the Boiler Cap is removed.