Steamfast SF-680 - Troubleshooting; Unit fails to heat up. Power Indicator Light DOES NOT illuminate.; Unit heats up, but fails to steam. Power Indicator Light does illuminate.; Steam Burst output is weak or intermittent.

ENGLISH
|
9
PROBLEM
Unit fails to heat up. Power
Indicator Light DOES
NOT illuminate.
Steam Burst output is weak
or intermittent.
Unit heats up, but fails to steam.
Power Indicator Light
does illuminate.
(NOTE: Always allow proper time
for unit to heat up and begin
producing steam.)
POSSIBLE CAUSE
Unit is not plugged in.
Water Tank is empty.
Auto Shut-Off has engaged.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or malfunctioning.
Pressing Plate needs to be cleaned.
SOLUTION
Plug power cord into
electrical outlet.
Refer to Filling Water Reservoir
procedure on Page 6.
Refer to Auto Shut-Off section
on page 8 of this manual for
proper procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage
and contact our Customer
Support department.
Refer to Cleaning the Digital Fabric
Steam Press section on page 8 of
this manual for proper procedure.
Troubleshooting